A furnace that won't light or keeps shutting off needs real diagnosis, not another reset. A CO check happens on every call, standard, not an upsell.
A short list of components causes most Furnace Repair calls: ignitor, flame sensor, gas valve, heat exchanger. Each gets tested with a multimeter and combustion analyzer, not replaced on a hunch, not parts-cannon guessing.
Safety and accuracy on every heating call.
Every repair includes a CO check, not optional.
No-heat calls in Cross River get priority routing over routine work during cold snaps when it's cold.
A fixed price is set before repairs start.
Both fuel types get the same trained tech, no exceptions.
The most common furnace failure points.
These two parts are behind most no-heat visits, usually a same-visit fix.
Gas valve testing confirms the fault before we recommend replacing it.
A cracked heat exchanger can leak combustion byproducts into the airflow — we inspect with a scope and analyzer rather than assuming based on age.
Short-cycling or mid-cycle shutdowns often trace to the limit switch or a struggling blower before condemning the control board.
Older Cross River furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
We rule out wiring issues first to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Describe the symptom and we route the nearest tech and we'll get someone moving.
Truck arrives stocked with common ignitor, flame sensor, and control parts ready to diagnose and often repair same visit.
Combustion analysis happens before any repair is quoted, then a flat-rate quote.
Most repairs finish same visit, with a final CO check before we leave, backed by warranty.
Feedback from completed furnace repairs.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
What Cross River customers ask most.
We always confirm with a proper reading before quoting.
Yes — it can let combustion gases into breathing air, we won't run a confirmed-cracked unit, taken seriously.
Yes, included at no extra charge, no upcharge.
Yes — thermocouple and draft-related repairs are covered.
No-heat calls get priority routing, usually same-day even during high demand.
Common parts are stocked, rare ones may need next-day ordering to finish the repair.
We dispatch heating techs throughout Cross River — call to confirm.
Confirm Coverage
